Sorry I dont have more pictures but this is all I have right now!
Engine on stand to install windage tray and oil pan gasket
On the RH side the gasket didnt quite line up so I had to make a couple minor mods with a razor. Still sealed up good I think.
Rear main seal was a bit of a bugger. The kit I got came with 2 seals, one was too small and the one was too big. I took this one, and cut the excess so it was flush with the oil pan. It sealed good upon installation of the pan so I think I'll be fine, i inspected it very close and I am satisfied.
Gramps and I putting the motor up on the forklift for installation into the boat.
You'll never see a 327F so HIGH in your life!!!

..and I mean that in the most literal way possible!
These 2 pictures are exactly the same, just 20 years apart!