Page 1 of 1

DIY 032 Window Switch Revival

Posted: Sun 14. Jun 2020, 07:10
by 59lincolnrag
REV B Added newer style switches.
REV C added detail to switch removal with coat hanger. 3/6/2021

Many of us have power windows, more specifically Lincolns.I just want to give you a quick overview of how to get your windows working again.
90 % of the time when a window will not operate it is the fault of the switch caused by corrosion and debris that has fallen into the mechanism.
Here is an overview of switch repair on a 1959 Lincoln.

20191014_142452.jpg
After removal of the switch panel each switch will need to be carefully removed.

20191015_161251.jpg
On the front and back of each switch there is a tiny hole in the chrome casting.

20210306_171005.jpg
Using a stiff wire coat hanger carefully push the locking tabs in to release the switch. Some WD-40 will help.


20210306_171300.jpg
Bend a 90 at one end and use this end to get at the inboard lock tabs.
There are two locking tabs per switch.

20191014_174313.jpg
There is a tiny finger that locks into the hole that retains the switch assembly.


20191014_142516.jpg
Now remove the center screw holding everything together.

20191014_142629.jpg
Using a Dremel and a cone brass brush clean out the switch cavity.

20191014_163543.jpg
Thoroughly clean all the parts. I used a brass brush tooth brush and Isopropyl Alcohol. Notice the deteriorated rubber that protected the switch at one time. More on that later.

20191014_153827.jpg
The main window power switch can be cleaned as well.

After this procedure my windows were working flawlessly.



Here is a quick overview of window switch of a 1966 Lincoln.
Capture2.JPG
Capture2.JPG (39.6 KiB) Viewed 3822 times
This is the newer style switch.

Capture8.JPG
Like on the previous switch they are held in by small clips. Push in the tab and pull up to remove. Its not an easy task.

Capture3.JPG
Once the switch assembly is out you can carefully disassemble it.

Capture5.JPG
Capture5.JPG (13.6 KiB) Viewed 3822 times
Remove the "E" clip.

Capture1.JPG
Capture1.JPG (19.01 KiB) Viewed 3822 times
Carefully drive out the retaining pin. The switch is only plastic so be extra careful.

Capture6.JPG
Capture6.JPG (14.19 KiB) Viewed 3822 times
Remove the spring and the pivot.

Capture7.JPG
Capture7.JPG (16.07 KiB) Viewed 3822 times
Using some emery cloth and contact cleaner carefully clean the contacts.
You should be good to go.
s-l640.jpg
s-l640.jpg (20.49 KiB) Viewed 3822 times
In addition to cleaning these switches. They can be protected by placing rubber nitrile finger cots over each switch for protection. Punch a round hole in the tip so it does not tear.

Re: DIY 032 Window Switch Revival

Posted: Sat 20. Jun 2020, 06:04
by 59lincolnrag
REV B Added newer style switches. 6/20/2020