looking at moroso offset dowl pins for indexing the bellhousing. there is a slot for the screwdriver and the number 14 stamped above it. Question:where is the high side on the dowl?

you should be able to see the offset in the dowel itself? Run your finger down the length of the dowel and you should be able to feel the difference in the diameter. Not sure if the slot has any correlation with the offset. I'm assuming the number 14 is the amount of offset? Not sure.


LarryK

1964 Galaxie 2dr 390/6-71/4spd
1964 Country Sedan Wagon 428/5spd
1969 F100 428/4spd
1967 F100 352/now a 4 spd!
1959 B Model Mack

http://www.robbmcperformance.com/products/dowels.html

Read the text explaining on the bottom half of the page.

they look much easier to use.

I notice you have three sizes. Do you offer a package so a person can have them on hand when they start their alignment and can complete it without having to stop and order the exact size and wait for it to ship. Are they mix & match? Also do you still have the thermostat housings on clearance.

Craig Mitchell
68 Mustang GT 428CJ

You can order all three offsets and then return the ones you don't use. We will refund your money (except shipping) for those sets you return.

We have nine of the thermostat housings remaining and yes they are still $50 for forum members. Just be sure to email me after you place your order and let me know you are a member so you will get your rebate check with the housing.